The Top Engine Mount is attached to the backbone. But support needs to come from somewhere so, for example, the builder might put 'struts' between the downtube and the neck stem. It improves the rigidity and provides support.īut many frames don't have a neck gusset. The Neck Gusset fuses it all together: It provides more support for the front end and the Neck Stem.Ī Neck gusset is an important piece of metal that is welded to the neck gusset tubing, stem, backbone, and also the bottom rails of the frame.Many frames also have what is called a Neck Gusset Tube: this is a piece of tubing that is attached with the top tube and the bottom rails.It is a very important part of the chopper chassis, and it requires a little more support. It's a piece of steel that has been specially machine to include ball bearings in order to fit the chopper or bobbers front-end (forks and steering). Neck Stem: the neck stem is forks and the chassis connect.The neck of the frame consists of 3 different sections:.Also note that you can see where a builder will install the Here Is The Chopper Frame As Described Above (Note the shape of the Many designers don't include one, but they make up for rigidity in other areas of the frame. The reason it there is because it helps the frame achieve better rigidity. The Seat Post is simply tubing which is welded in place between the backbone and the crossbrace which is between both of the bottom rails of the chopper frame (you can see an image of that below). The Downtubes consists of the area which lies between the neck stem and where it bends.But, if you are building softail chopper frames then you will weld them to the side plates. The Bottom Rails are fused to the neck stem and the rear part of the wishbone tubing. This area of the frame is welded to both the wishbone frame tubing and the neck stem. The next part of the a chopper frames construction is called the Backbone (a.k.a.The reason these pieces of welded together tubing are called the wishbone is because they look line one, once the welding of the frame is complete, or at least that part of it (you'll see in a moment). If you are building a softail frame the tubing is welded to the side plates. They are also welded to the backbone (also known as the top tube) and the bottom rails of the rigid chopper frame. The wishbone tubes are welded to one another. The wishbone consists of two pieces of tubing which are bent in such a way as to make room for the chopper or bobber saddle (bobber style frames are basically the same thing as a chopper frame. Wishbone: The wishbone tubing is found on the top of the frame and on the rear end of the frame.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |